Appendix; Troubleshooting - Pioneer AVIC-X1BT Hardware Manual

Appendix

Troubleshooting

➲ Troubleshooting problems other than those described below ➞ Appendix of the Operation Manual
Symptom
No picture.
The picture is
stretched, the aspect is
incorrect.
Rear display picture
disappears.
Nothing is displayed
and the touch panel
keys cannot be used.
Volume of beeps and
navigation guidance
cannot be adjusted.
Playback is not possi-
ble.
LCD Panel knocks
against your vehicle's
console or dashboard.
Video image appears
grainy.
Cause
The handbrake cord is not connected.
The handbrake is not applied.
The aspect setting is incorrect for the dis-
play.
The source disc being played back with the
navigation system has been ejected.
The REAR/GUIDE button was pressed and
REAR ON mode switched off.
There was a problem with the rear display
or a faulty wiring connection, for example.
Rear View is selected on the screen.
When the gear stick is in [R], the screen dis-
plays rear view camera images. (When
"NAVI" is selected in REAR DISP menu.)
A source without video is selected.
Operating PICTURE ADJUSTMENT.
The setting for the rear view camera is
incorrect.
The gear stick was placed in [R] when the
rear view camera was not connected.
You cannot adjust these parameters with
the VOLUME/ATT button.
The disc is dirty.
The loaded disc is a type your navigation
system cannot play.
Non compatible video system disc is
loaded.
The loaded disc has a different region
number from the navigation system.
Incorrect angle setting.
This happens when videos are viewed in
CINEMA or ZOOM mode.
Action (See)
Connect the handbrake cord, and apply the
handbrake.
Connect the handbrake cord, and apply the
handbrake.
Select the appropriate setting for your dis-
play. (➞ "Changing the Wide Screen Mode"
and "Operating the Picture Adjustment" in
the Operation Mannual.)
Before ejecting the disc, switch the source.
This problem may occur when certain con-
nection methods are used.
Press the REAR/GUIDE button to turn
REAR ON mode on.
Check the rear display and its connection.
Select view mode other than Rear View.
Move the gear stick to a position other than
[R]. (Select "SOURCE" in REAR DISP
menu.)
Switch to a source with a video.
There is no picture on the rear display while
PICTURE ADJUSTMENT is carried out.
Connect a rear view camera correctly.
Press the NAVI/AV button to return to the
source display and then select the correct
setting for CAMERA.
➲ About CAMERA setting
Manual
• Turn the volume up or down with
"Volume" in the Setting menu.
• Press the REAR/GUIDE button ond turn
the volume up or down.
Clean disc.
Check what type the disc is. (➞ Page 18)
Change to a disc compatible to your video
system. (➞ Page 18)
Replace the disc with one featuring the
same region number as the navigation sys-
tem. (➞ Page 6)
Press the ANGLE (+/–) button to adjust the
LCD angle. Forcibly adjusting the LCD panel
by hand may damage it.
Select a different mode to view videos.
➞
Operation
17