Table of Contents
Advertisement
Additional Information
DSP
Symptom
Speakers are not available to be
adjusted.
Time alignment is not available. Listening position is not set cor-
The subwoofer is not available to
switch its phase.
Bass content is not heard.
Ocassionally no sounds are out-
put when Dolby Pro Logic II is
turned on.
Occasionally no sounds are
heard over speakers other than
the center one.
Turning dynamic range control
on has no effects.
No sounds are heard.
Error messages
When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error
message.
Message
ERROR02-02
R ERROR
NON-PLAY
HEAT
Cause
Their size settings is at OFF.
rectly.
Speaker size settings is at OFF.
The subwoofer is set to OFF.
The subwoofer is set to OFF and yet
other speakers are set to OFF or
SML in size.
The center speaker setting is at SML
or LRG whereas no center speaker
is installed.
Dolby Pro Logic II is turned on.
The currently reproduced sound is
not Dolby Digital coded.
Optical cables are incorrectly con-
nected.
Cause
Dirty disc
Scratched disc
The disc is loaded upside down
The disc does not have the same re-
gion number as this unit
This type of disc cannot be played
by this unit
The temperature of this unit is out-
side the normal operating range
Action (See)
Make the correct size settings. (Page 76)
Set listening position correctly. (Page 70)
Make the correct size settings. (Page 76)
Set the subwoofer to ON. (Page 76)
Make the correct settings. (If no subwoofer is
installed, the front or rear speaker needs to
be set to LRG.) (Page 76)
Change the center speaker size setting to
OFF. (If the audio source is mono and Dolby
Pro Logic II is turned on, sound is heard over
the center speaker only.) (Page 76)
Turn Dolby Pro Logic II off. (If the audio
source is mono and Dolby Pro Logic II is
turned on, sound is heard over the center
speaker only.) (Page 70)
The feature is only effective on Dolby Digital
sounds. (Page 71)
Connect the cables correctly.
Action
Clean disc.
Replace disc.
Check that the disc is loaded correctly.
Replace the DVD video with one bearing the
correct region number.
Replace the disc with one this unit can play.
Wait until the unit's temperature returns to
within normal operating limits.
Appendix
83
En
Advertisement
Table of Contents
