Storage Drawer Removal - GE Compact Electric Free-Standing Ranges Owner's Manual

Maintenance (Cont.)
Lift-Off Oven Door
WARNING
To remove the door:
1. Open the door to the full open position.
2. Pull the hinge locks up over the hinge hooks on both
sides.
3. Grasp the door firmly on each side, lift slightly and
pull it straight out and away from the oven.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Insert and seat the upper and lower hinge arms into
the oven slots.
3. Push the hinge locks down from the hinge hooks.
4. Close the oven door and make sure it is working
properly. If it is not working properly, remove and
replace it following the above steps.
THIS STEP IS COMPLETE. THE HINGE OR DOOR

Storage Drawer Removal

To remove the drawer:
1. Pull the drawer out until it stops.
2. Lift the front of the drawer until the stops clear the
guides.
3. Remove the drawer.
To replace the drawer:
1. Place the drawer rails on the guides.
2. Push the drawer back until it stops.
3. Lift the front of the drawer and push back until the
stops clear the guides.
4. Lower the front of the drawer and push back until it
closes.
49-88058
If improperly removed, oven door hinges may suddenly open and can cause personal injury
to appendages near the hinge. Follow instructions below to avoid a risk of injury when
removing and re-installing the oven door.
Slot
Hinge
lock
Upper hinge arm
Rail
Lower hinge arm
Stop guide
27