Manual Mig Welding Set-Up Menu - Miller Electric MPi 220P Owner's Manual

5-6. Manual MIG Welding Set-Up Menu

2
5
2T
3
0
2
1
Press And Hold
SCROLL THROUGH SEQUENCERS
6
0.02S
3
0
1
Press And Release
4
3
3
0
0
7
0.0S
3
To enter MIG welding set-up menu,
proceed as follows:
1 Sequencer Set-Up P2 Push
Button
2 Wire Feed Speed (WFS)
Adjustment Knob
While in the set-up menu, use knob
to change sequencer parameters.
3 Sequencer
Adjustment/Operator Point
Setting P3 Push Buttons (See
Section 5-16)
4 Process Selection P1 Push
Button
Press and hold P2 push button to
enter into the set-up menu. Se-
quencers will be displayed on the
digital meter display. To change
parameters, use P3 push buttons
or Wire Feed Speed (WFS) adjust-
ment knob. To scroll through se-
quencers, press and release P2
push button. To exit from set-up
menu, press and release process
selection P1 push button and de-
sired parameters will be stored.
5 Trigger Mode (2T/4T)
Use the Wire Feed Speed adjust-
ment knob or Sequencer adjust-
ment P3 push buttons to change
the value (see Section 5-7).
6 Slope Time
Use control to select amount of time
that it takes to slope up/down from
initial amperage to weld amperage.
To disable, set to 0. When this item
is selected, use the Wire Feed
Speed adjustment knob or Sequen-
cer adjustment P3 push buttons to
change the value. Default = 0.2
seconds (min = 0 sec, max = 1.5
sec).
7 Burnback Time (BBT)
Time that welding wire stays
energized after trigger is released.
This is a predetermined value in
MIG mode and cannot be changed.
8 Weld Output Inductance
Use control to select inductance
value. When this is selected, use
the Wire Feed Speed adjustment
knob or Sequencer adjustment P3
8
push buttons to change value. De-
fault = 0 (min = 0, max = 11). Low in-
ductance is used for most short arc
applications. High inductance is for
9 stainless steel and spray arc ap-
plications.
Ref. 956142881_9-A
OM-253 918 Page 27