Controls Without Meters - Miller Electric SuitCase X-TREME 8 HD Owner's Manual

5-2. Controls Without Meters

Internal Side View
OM-246 828 Page 20
1
2 3
Front Panel Without Meters
5
Internal Control Panel
1 Wire Speed Control
Use control to adjust wire speed within the
speed range selected by the wire speed
range switch, located on the inner control
panel. Maximum wire speed may be limited
by arc voltage.
2 Jog/Purge Switch
Pressing the Jog switch allows the operator
to jog wire without energizing the contactor
or gas valve.
Pressing the Purge switch allows the opera-
tor to purge gas lines before welding and to
preset gas flow rate at the flowmeter.
3 Trigger Hold Switch (Optional)
Trigger hold allows operator to weld without
holding gun trigger.
To use trigger hold function, place trigger
hold switch in the ON position.
The operator must hold the trigger for a mini-
mum of 2 seconds, but no longer than 6 sec-
onds before releasing it. Welding will contin-
ue when trigger is released.
To stop welding, press and release the trig-
4
ger.
4 Power Control Switch
5 Soft Start Switch
The Soft Start feature provides a smooth
start during most weld conditions. When the
trigger is pulled, the wire speed is approxi-
mately 50% of the weld wire speed, as set by
the wire speed control knob. After an arc is
established, the wire speed increases to the
weld wire speed.
When using small diameters wire, or with in-
verter power sources, it may be necessary to
turn switch off to obtain smooth starts.
6 HI/LO Speed Range Switch
6
Use switch to select speed range. High
7
range is 50 to 780 Inches per minute. Low
range is approximately half of high range.
7 CC/CV Switch
Use switch to match feeder with the output of
the power source.
After adjusting the switches, close and latch
the door before welding.
Ref. 804 855-A / 804 876-A