Aligning Drive Rolls And Wire Guide; Removing Knob From Front Panel - Miller Millermatic Pulser M-15 Gun Owner's Manual

5-6. Aligning Drive Rolls and Wire Guide

Tools Needed:

5-7. Removing Knob From Front Panel

3
2
Correct
4
3
2
1
4
Return To Table Of Contents
Incorrect
5
1
Y Turn Off power.
View is from top of drive rolls look-
ing down with pressure assembly
open.
1 Drive Roll Securing Nut
2 Drive Roll
3 Wire Guide
4 Welding Wire
5 Drive Gear
Insert screwdriver, and turn screw
in or out until drive roll groove lines
up with wire guide.
Close pressure roll assembly.
Ref. ST-800 412-A
Y Turn Off power.
1 Front Panel
2 Knob
3 Slot
4 Control Shaft
Rotate knob to allow access to slot.
Insert tip of screwdriver into slot,
and while pushing on spring clip,
pull knob off control shaft.
To reinstall, push knob fully onto
control shaft.
803 346 / 802 717-C
OM-1322 Page 29