Digital Performer - Roland A-300 Pro Control Manual

Control Map Guide

Digital Performer

If you're using Digital Performer, make the following settings.
The explanation here uses Digital Performer 7 as an example. The procedure might differ if you're using a different version.
Operation of the A-PRO
1
mode)" in the owner's manual.)
2 Operation of the A-PRO
the cursor to "CTRL MAP" in the display.
The display shows the number of the currently selected control map.
Operation of the A-PRO
3
4
Start up Digital Performer 7.
5
In the [Setup] menu, click [Control Surface Setup...].
6
In the "Control Surface" dialog box, click the [+] box, and make the
following settings.
Driver Mackie Control
Unit Mackie Control
MIDI A-PRO 2-1
6
Choose PLAY mode (see "Performing (Play
Press the [ ] button or [ ] button to move
Turn the [VALUE] knob to select number 9.
Functions Assigned to the Controllers
Refer to p. 10.
Troubleshooting
Values, such as that for pan, change even though you didn't adjust
them
Make sure that knobs [R1]–[R9] are in the center position.
Encoder Simulate is assigned to Knobs [R1]–[R9]. If knobs [R1]–[R9] are not at the center
position, control messages will continue to be transmitted from the A-PRO.
You can control PLAY or STOP, but not Volume or Pan
Check the track that is set to "channel 1."
Pressing the [B1] button or [B2] button will switch the tracks that are assigned to sliders
[S1]–[S8] and knobs [R1]–[R8]. It is not necessarily the case that [R1] and [S1] are
assigned to track 1.