Table of Contents
Advertisement
78
External Speaker Installation
1.
Remove the speaker from the trunnion bracket by loosening the two wing screws.
2.
Choose a place to mount the speaker. When mounting the trunnion on the transmission
hump, be careful that the transmission housing is not affected.
3.
Use the trunnion bracket as a template to mark the positions of the mounting holes.
4.
Centre-punch the spots you marked and drill a 4 mm (5/32-inch) diameter hole at each
location.
5.
Mount the trunnion bracket with the screws supplied (see Figure 37).
6.
Insert the speaker into the trunnion bracket and tighten the two wing screws.
7.
Insert the external speaker accessory plug into the accessory connector of the radio.
MTM5400 Mobile Terminal Installation Manual
Figure 37 Mounting the Speaker under the Dashboard
INSTALLATION
Advertisement
Table of Contents
