Power Supply - Kenwood TK-2102G Service Manual

3) VCO and RF Amplifi er
The transmit signal obtained from the VCO buffer am-
plifi er Q100, is amplifi ed by Q101. This amplifi ed signal is
passed to the power amplifi er, Q102 and Q105, which con-
sists of a 2-stage FET amplifi er and is capable of producing
up to 5W of RF power. (See Fig.7)
AMP
Q101
5T
DET
Q103,104
B SW
B
APC
TH100
5T
SW
Q107
5) APC
The automatic power control (APC) circuit stabilizes the
transmitter output power at a predetermined level by sens-
ing the drain current of the fi nal amplifi er Field Effect Tran-
sistor (FET) . The voltage comparator, IC100 (2/2), compares
the voltage obtained from the above drain current with a
reference voltage which is set using the microprocessor.
An APC voltage proportional to the difference between the
sensed voltage and the reference voltage appears at the
output of IC100 (1/2). This output voltage controls the gate
of the FET power amplifier, which keeps the transmitter
output power constant. The transmitter output power can
be varied by the microprocessor which in turn changes the
reference voltage and hence, the output power.
6) Thermal Protection Circuit
When the thermistor (TH100) reaches about 80˚C, the
protection circuit turns on Q107 to protect transmitting fi nal
amplifi er (Q105) from the over heating.
CIRCUIT DESCRIPTION
DRIVE AMP
FINAL AMP
Q102
Q105
APC
Q109
SW
IC100
5T
Q108
SW
5T
Fig. 7 APC system
4) ANT Switch and LPF
The RF amplifi er output signal is passed through a low-
pass fi lter network and a transmit/receive switching circuit
before it is passed to the antenna terminal. The transmit/
receive switching circuit is comprised of D101, D102, D103
and D104. D102 and D103 turned on (conductive) in trans-
mit mode and off (isolated) in receive mode.
ANT SW
D101,104
ANT SW
Q106
D102,103
SW
RX

5. Power Supply

A 5V reference power supply [5M] for the control circuit
is derived from an internal battery. This reference is used
to provide a 5V supply in transmit mode [5T], a 5V supply in
receive mode [5R], and a 5V supply common in both modes
[5C] based on the control signal sent from the microproces-
sor.
6. Control System
The IC403 MPU operates at 7.37MHz . This oscillator has
a circuit that shifts the frequency according to the EEPROM
data.
TK-2102G
ANT
LPF
9