Yamaha YZ250(V) Owner's Service Manual page 460

HANDLEBAR
NOTE:
9 The handlebar holder (upper) should be
installed with the punched mark a forward.
9 Install the handlebar so that the marks b are in
place on both sides.
9 First tighten the bolts on the front side of the
handlebar holder (upper), and then tighten the
bolts on the rear side.
3. Tighten:
9 Nut [handlebar holder (lower)] 1
4. Install:
9 Grip (left) 1
Apply the adhesive to the handlebar 2.
NOTE:
9 Before applying the adhesive, wipe off grease
or oil on the handlebar surface a with a lac-
quer thinner.
9 Install the grip (left) to the handlebar so that the
line b between the two arrow marks faces
straight upward.
5. Install:
9 Collar 1
9 Cap cover 2
9 Throttle 3
NOTE:
9 Apply the lithium soap base grease on the
throttle grip sliding surface.
9 Tighten the grip cap bolts temporarily without the
throttle being fixed to the handlebar.
5-46
CHAS
40 Nm (4.0 m•kg, 29 ft•lb)