Toshiba NB510 User Manual page 74

Do not install or remove a memory module while Wake-up on LAN is
enabled.
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the
section in chapter 5, Power and Power-Up Modes.
Enabled
Disabled
Built-in LAN
This feature enables or disables the Built-in LAN.
Enabled
Disabled
USB
Legacy USB Support
Use this option to enable or disable USB Legacy Emulation. If your
operating system does not support USB, you can still use a USB mouse
and keyboard by setting the Legacy USB Support item to enabled.
Enabled
Disabled
SATA
SATA Interface setting
This feature allows you to set SATA interface setting.
User's Manual
The Wake-up on LAN function consumes power even when the
system is off. Leave the AC adaptor connected while using this
feature.
Regarding Wake-up on LAN from sleep or hibernation, you must
check the "Allow the device to wake the computer" check box within
the LAN Device properties. (This feature does not effect the Wake-up
on LAN from sleep or hibernation.)
Retaining data with power off
Enables Wake-up on LAN from shutdown.
Disables Wake-up on LAN from shutdown.
(Default)
Enables Built-in LAN functions. (Default)
Disables Built-in LAN functions.
Enables the USB Legacy Emulation. (Default)
Disabled Disables the USB Legacy Emulation.
NB510
4-11