GE Spacemaker JVM150K Use And Care & Cooking Manual page 36

PROBLEM
OVEN W~L NOT
COME ON
CONTROL PANEL
LIGHTED, YET OVEN
ON DISPLAY
"Error" APPEMS
ON DISPLAY
FLOOR OF THE OVEN
IS WARM, EVEN
WHEN THE OWN
HAS NOT BEEN USED
Steam or vapor escaping from around the door.
Light reflection around door or outer case.
Dimming oven light and change in blower sound
may occur while operating at power levels other
than high.
If you need more help... call, toll free: GE Answer Center
36
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or
reset circuit breaker.
Make sure 3-prong plug on oven is fully inserted into wall receptacle.
Door not securely closed.
START pad must be touched after entering cooking selection,
cancel it.
START pad.
Make sure you have entered a temperawre after touching TEMP COO~OLD pad.
Make sure you have entered a code number tier touching AUTO ROAST or AUTO
Probe has been forgotten or not seated properly in oven wall when using Temp
During Auto Cook, Auto Reheat or Popcorn program, the door was opened before
steam could be detected, or steam was not detected in mmimum time.
No steam was detected by sensor within 4 minutes and 10 seconds after start of
Popcorn program.
is on, the heat it produces makes the oven floor get warm. This is norrnd.
All these things are normal with your microwave oven:
Dull thumping sound while oven is operating.
Some TV-Radio interference might be noticed
while using your microwave oven. It's similar to
the interference caused by other small appliances
and does not indicate a problem with your oven.
@
/ 800.626.2000/ consumer information service