Trcm Performance Adjust Menu Description - Invacare MK5 EX Service Manual

PERFORMANCE ADJUST
STANDARD PROGRAMS
ACTUATOR SELECTION
CURRENT STATUS

TRCM Performance Adjust Menu Description

MENU ITEM
TILT UP SPEED
TILT DOWN SPEED
RECLINE UP SPEED
RECLINE DOWN SPEED
VSR UP SPEED (2G)
VSR DOWN SPEED (2G)
LEG UP SPEED
LEG DOWN SPEED
LEGREST BALANCE
ACCELERATION
DECELERATION
LIMIT SELECTION
DRIVE LOCKOUT LIMIT
D/L BY DRIVE
TILT UP LIMIT
TILT DOWN LIMIT
RECLINE UP LIMIT
RECLINE DOWN LIMIT
Part No 1114808
Adjusts the speed that the Tilt Actuator moves the seat toward the upright
position.
Adjusts the speed that the Tilt Actuator moves the seat into the tilted posi-
tion.
Adjusts the speed that the Recline Actuator moves the back into the upright
position.
Adjusts the speed that the Recline Actuator moves the back into the
reclined position.
Adjusts the speed that the Vernier Shear Reduction (VSR) actuator moves
upward.
Adjusts the speed that the VSR actuator moves downward.
Adjusts the speed that the power leg actuators extend the legrests.
Adjusts the speed that the power leg actuators retract the legrests.
Adjusts the speed balance between left and right legrest actuators.
Adjusts the rate that all of the actuators approach their respective pro-
grammed speeds (Start up speed).
Adjusts the rate that all of the actuators are brought to a stop (Braking
speed).
There are two types of limits. Potentiometers are capable of measuring seat
angles directly. Switches are mercury switches which are mechanically
adjusted to provide the limit function. Select the type of limit that is installed
on the seating system; POT for potentiometer or M.Sw for mercury
switches.
If POT limit type was selected, there are five limit angles which can be
adjusted. All angles are measured from horizontal being 0°.
Adjusts the maximum angle that the back can be tilted or reclined and still
allow driving of the wheelchair. In Tilt only systems, the back angle is
assumed to be 90° greater than the seat angle. Range 90° - 110°.
Turns drive lock-out on or off for a chosen drive.
When drive lock-out is programmed OFF the wheel-
chair can be driven at any tilt/recline angle. The drive
lock-out safety feature will be disabled for the drive
that has been programmed OFF. It is recommended
that drive lockout only be turned off in a chosen drive
for special driving situations.
Adjusts the angle that the Tilt Actuator will stop when moving to the
upright position. Range 0° - 50°.
Adjusts the angle that the Tilt Actuator stops tilting back the seat. Range 0°
- 50°.
Adjusts the back angle at which the Recline Actuator will stop raising the
seat back to the upright position. Range 90° - 170°.
Adjusts the maximum reclined back angle for the Recline Actuator. Range
90° - 170°.
61
SECTION 10—OPTIONS
DESCRIPTION
WARNING
™ ™ ™
MK EX and MK
5 5
™
TT-EX Electronics