Jenn-Air 30" (76.2 CM) Installation Instructions Manual page 21

To Convert Gas Pressure Regulator
1. Remove access panel by grasping sides and pulling upward,
lifting out.
2. Locate gas pressure regulator behind access panel.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
3. Unscrew the regulator cap and remove the plastic cover.
A. Plastic cover
B. Regulator cap
4. Flip the regulator cap over and replace the plastic cover.
A
A. Natural gas position
B. LP gas position
C. Plastic cover
5. Screw the regulator cap securely back into place. Do not
overtighten.
A
B
B
C
To Convert Oven Bake Burner
1. Remove oven racks from inside the oven cavity.
2. Remove the oven door. See "Oven Door" section in the Use
and Care Guide for oven door removal instructions.
3. Using a Phillips screwdriver, remove and set aside the 2 oven
bake burner cover screws located at the front of the oven.
B
A. Oven bake burner cover
B. Oven bake burner cover screws
4. Lift up and remove oven bake burner cover.
5. Unscrew 2 wing nuts and remove oven baffle.
A
6. Using a Phillips screwdriver, remove and set aside the 2 oven
bake burner screws and the orifice hood cover screw.
A
A. Oven bake burner screws
B. Orifice hood cover
7. Lift up and remove orifice hood cover.
8. Lift up and remove oven bake burner.
A
A. Oven baffle
B. Wing nuts
B
C. Orifice hood cover screw
D. Oven Bake burner
B
C
D
21