Installing The Control Panel - Miele G 870 Operating Instructions Manual

Dishwasher installation

3. Installing the control panel.

The control panel and hardware is packaged separately from the dishwasher. It
should be installed using the following procedure.
If a GDU decor kit is being used, (to
convert an "i" diswasher to a "U" ver-
sion), the spacer bars
removed and stored for possible use
in the future, (See the separate in-
structions for installing the GDU
decor kit). If the GDU kit is not being
used, skip the following step.
To remove the spacer bars from the
control panel, place the panel on a
table, printed side up, and gently
push down on the spacer bars at a
point near the bottom of the control
panel. This will release the mounting
bolts from their slots.
48
h
must first be
Install the necessary spacer bars
on the control panel.
Place the supplied seal
c
ventilation grill.
Push the ventilation grill
metal backing plate.
Place the cover strip
pushbutton switches.
Place the control panel
backing plate and fasten it from the
inside of the door
screws provided.
Align and press the program knob
g
onto its shaft .
h
b
onto the
.
c
into the
d
over the
e
over the
f
using the six