Installing A Flash Memory Or Firmware Card - Lexmark E460dw User Manual

Installing a flash memory or firmware card

The system board has two connections for an optional flash memory or firmware card. Only one of each may be
installed, but the connectors are interchangeable.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have other devices attached to the printer, then turn them off as well, and
unplug any cables going into the printer.
Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touch
something metal on the printer before touching any system board electronic components or connectors.
1
Open the system board door.
2
Unpack the card.
Note: Avoid touching the connection points along the edge of the card.
3
Holding the card by its sides, align the card with the connector on the system board.
Additional printer setup
24