Step 2: Install The Pc-Dkt Card - Toshiba PC-DKT User Manual

—————————————————————————————————

Step 2: Install the PC-DKT Card

Important! You must install the PC-DKT card before installing the PC-DKT
software.
Since this is not a "plug-and-play" device, you must configure the PC-DKT card's
IRQ and Memory Address settings. In order to configure the card's settings, you must
first find out what settings are available on your PC.
To install the PC-DKT card
1. Check for available IRQ and memory address settings on your PC. The factory
default is IRQ 5 and Address 380h. If these are not available, choose an available
IRQ and Address (see valid Interrupts and Addresses in
Windows 95: from the Taskbar, click Start, Settings, then Control Panel. Double-
click the System icon. Click the Device Manager tab and make sure "Computer"
is highlighted. Click Properties button. By clicking on "Interrupt request (IRQ)"
and "Input/output (I/O)," you can view the settings for the system.
Windows 3.11: exit the DOS C:\ prompt and run Microsoft Diagnostics (type
MSD.EXE).
2. Exit all open applications.
Windows 95: From the Taskbar, click Start, then Shut Down. You are asked to
confirm the shutdown.
Windows 3.1/3.11: From the Program Manager's windows, click File, then Exit
Windows to go to the DOS prompt.
WARNING! Avoid electrical shock! Make sure the power is off before moving
or removing the computer cover.
3. Power off the PC and disconnect all cables.
Make sure you are properly grounded with a grounding strap before
CAUTION!
opening the computer.
Installation
Step 2: Install the PC-DKT Card
Table 2).
11