HP 9000 EPS20 Installation Manual page 7

Optional Graphics Console
If desired, a graphics console and mouse can be connected to the SPU instead of the standard console.
To install the graphics console, substitute the following Step 1 for the standard Step 1 in the installation
procedure listed above:
Optional Graphics Console: A4032A/A4033A/A4331A Graphics Display with Keyboard and
Mouse:
1. Connect the graphics console data cable to the "OPTIONAL I/O" port on the system core I/O card.
2. Plug the graphics console power cable into a UPS power receptacle.
3. Plug the graphics console power cable into a UPS power receptacle.
4. Connect the keyboard cable to the keyboard connector on the core I/O card.
5. Connect the mouse cable to the connector labeled "MOUSE" on the system core I/O card.
6. Connect the UPS data cable between the "UPS" connector on the system and the appropriate data
connector on the UPS.
Overview of System Power/Data Cabling
CAUTION
UPS Requirements
The 1.8kVA (A2997A), 3kVA (A2998A), and 5.5kVA (A3589A) Power Trust UPSs
are the only UPSs supported on PA8000-based systems: HP9000
K250/K260/K370/K380 and HP9000 K450/K460/K570/K580. The 1.3kVA and
1.6kVA Power Trust UPSs do not have a 20amp receptacle and cannot provide
sufficient current.
Rackmount Requirements
Ensure that the PDU (cabinet power strip) has a 20 amp receptacle. Upgrade kits for the
PDU strip are available if required.
Introduction
Overview of System Installation
3