HP ProCurve 6120G/XG Manual page 511

Syntax: show port-access authenticator [port-list]
[config | statistics | session-counters | vlan | clients | clients detailed
ProCurve(config)# show port-access authenticator
Port Access Authenticator Status
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : Yes
Auth Unauth
Port Clients Clients
---- ------- -------- + -------- ------ -------- -----
1 1 1
2 2 0
3 4 0
...
Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
• Untagged VLAN: VLAN ID number of the untagged VLAN
used in client sessions. If the switch supports MAC-based
(untagged) VLANs, MACbased is displayed to show that
multiple untagged VLANs are configured for
authentication sessions.
• Tagged VLANs: Are tagged VLANs (statically configured or
RADIUS-assigned) used for authenticated clients?
Yes or No
• Port COS:
Yes - Client-specific CoS (Class of Service) values are
applied to more than one authenticated client on the port.
No - No client-specific CoS values are applied to any
authenticated client on the port.
<cos-value>- Numerical value of the CoS (802.1p
priority) applied to inbound traffic from one
authenticated client. For client-specific per-port CoS
values, enter the show port-access web-based clients detailed
command.
• % In Limit:
Yes - Per-port rate-limiting is applied to inbound traffic
from more than one authenticated client.
No - Per-port rate-limiting is not applied to any
authenticated client session.
<rate-limit-value>- Percentage value of a port's
bandwidth applied as a rate limit to one authenticated
client.
Information on ports not enabled for 802.1X port-access
authentication is not displayed.
| Untagged Tagged Port
| VLAN VLANs
| 4006 Yes
| MACbased No
| 1 Yes
Cntrl
COS Dir
70000000
Yes
No
12-55