Canon iR4570 User Manual page 64

4
Load the paper stack into the paper drawer.
Even out the edges of the paper stack. Load the paper
stack against the right wall of the paper drawer.
When loading paper into the paper drawer for the first
time, set the paper size dial to match the paper size
being loaded. (See "Adjusting a Paper Drawer to Hold a
Different Paper Size," in the Reference Guide.)
When loading paper into the paper drawer, make sure
that the paper size setting is the same size of the paper
that is being loaded.
2
IMPORTANT
Paper which has been rolled or curled must be straightened out prior to use.
Make sure that the height of the paper stack does not exceed the loading limit mark (
the paper drawer.
NOTE
Each paper drawer holds approximately 550 sheets of paper (80 g/m
For more information on the print direction of preprinted paper (paper which has logos or patterns
already printed on it), see "Relationship between Original Orientation and Preprinted Paper Output
Chart," in the Reference Guide.
5
Gently push the paper drawer back into
the machine until it clicks into place in
the closed position.
CAUTION
When returning the paper drawer to its original
position, be careful not to get your fingers caught,
as this may result in personal injury.
IMPORTANT
You will not be able to make copies or print if you load
paper that exceeds the loading limit, or if the paper
drawer is not completely pushed into the machine.
Always check that the paper drawers are in place. If a
paper drawer is overloaded, decrease the amount of
paper so that it does not exceed the loading limit.
2-4
Loading Paper
) at the back of
2
).