Toshiba MMY-MAP0804FT8-E Owner's Manual page 18

1-way cassette type
(YH series)
Vertical adjustment
▼ When cooling
Point the louver horizontally to send cool air across the
entire room.
▼ When heating
Point the louver downward to send heated air to the
floor.
Horizontal adjustment
To send air horizontally, point the vertical grilles inside
the louver in your preferred direction.
NOTE
To improve the cooling/heating performance, change
the louver angle for each running mode.
33-EN
Floor standing type
Vertical adjustment
▼ When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼ When heating
Move the louver manually and point it downward to
send heated air to the floor.
Horizontal adjustment
▼ Sending air in different directions
Lift up the vertical louvers slightly and point them in
your preferred directions.
2
1
In this case, do not use the
auto swing function.
– 17 –
Floor standing cabinet type
▼ When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼ When heating
Move the louver manually and point it downward to
send heated air to the floor.
◆ Changing the air discharge
Follow the procedure below to change the air
discharge:
1
Remove the two fixing screws of the air
discharge. (The fixing screws are to be
reused)
2
Insert your hand into the air discharge and
pull it up slightly, then remove the air
discharge from the claw hook at the rear
side.
3
Lift up the air discharge and remove it.
4
Reverse the air discharge and reattach it to
the main unit.
Make sure that the four claw hooks (2 at the rear
and 2 at the lower sides) are hooked into the
mounting positions.
5
Be sure to tighten the air discharge with the
removed fixing screws so that it does not
come off.
34-EN