Maintenance - Chamberlain PREMIUM series User Manual

For residential use only
Hide thumbs Also See for PREMIUM series:
Table of Contents

Advertisement

Available languages

Available languages

Maintenance

EVERY MONTH
• Manually operate door. If it is unbalanced or binding, call a trained door systems
technician.
• Check to be sure door opens and closes fully. Adjust if necessary, see page 10.
• Test the safety reversal system. Adjust if necessary, see page 11.
EVERY YEAR
• Oil door rollers, bearings and hinges. The garage door opener does not require additional
lubrication. Do not grease the door tracks.
• (If applicable) Test the battery backup and consider replacing the battery to ensure the
garage door opener will operate during an electrical power outage.
Testing the Battery Backup:
1. Unplug the garage door opener. The battery status LED will either glow solid orange
indicating opener is operating on battery power or will fl ash indicating low battery
power.
2. Open and close the door using the remote control or door control.
NOTE: The garage door opener may run slower if the battery is not fully charged.
The battery will take 24 hours to fully charge.
3. Plug in the garage door opener. Verify the battery status LED is fl ashing green,
indicating the battery is charging.
EVERY TWO TO THREE YEARS
• Use a rag to wipe away the existing grease from the garage door opener rail. Reapply a
small layer of white lithium grease to the top and underside of the rail surface where the
trolley slides.
The Remote Control Battery
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fi re, explosion or chemical burn:
• Replace ONLY with 3V2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.
The lithium batteries should produce power
for up to 5 years. If the battery is low, the
remote control's LED will not fl ash when the
button is pressed. To replace battery, pry
open the case fi rst in the middle (1), then at
each side (2 and 3) with the visor clip. Insert
battery positive side up.
Replace the batteries with only 3V2032
coin cell batteries. Dispose of old batteries
properly.
NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment or modifi cations of this transceiver are
prohibited. THERE ARE NO USER SERVICEABLE PARTS. Any changes or modifi cations not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
AVIS : Les règles de la FCC et/ou d'Industrie Canada (IC) interdisent tout ajustement ou toute modifi cation de ce
récepteur. IL N'EXISTE AUCUNE PIÈCE SUSCEPTIBLE D'ÊTRE ENTRETENUE PAR L'UTILISATEUR. Tout changement
ou toute modifi cation non expressément approuvé par la partie responsable de la conformité peut avoir pour résultat
d'annuler l'autorité de l'utilisateur de faire fonctionner l'équipement.
Cet appareil est conforme aux dispositions de la partie 15 du règlement de la FCC et de la norme IC RSS-210. Son
utilisation est assujettie aux deux conditions suivantes : (1) ce dispositif ne peut causer des interférences nuisibles, et (2)
ce dispositif doit accepter toute interférence reçue, y compris une interférence pouvant causer un fonctionnement non
souhaité.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
12
3
1
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Liftmaster premium series

Table of Contents