Transmitting; Selecting An Output Power; Selecting A Frequency; Vfo Mode - Kenwood TM-281E Instruction Manual

TRANSMITTING

1 To transmit, hold the microphone approximately 5 cm
(2 inches) from your mouth, then press and hold Mic
[PTT] and speak into the microphone in your normal
tone of voice.
• " " and the RF Power meter appears. The RF
Power meter shows the relative transmit output power
(
• If you press Mic [PTT] while you are outside the
transmission coverage, a high pitched error beep sounds.
2 When you finish speaking, release Mic [PTT].
Note: If you continuously transmit for longer than the time specified
in Menu No. 21 (default is 10 minutes) {page 62}, the internal time-
out timer generates a warning beep and the transceiver stops
transmitting. In this case, release Mic [PTT] and let the transceiver
cool down for a while, then press Mic [PTT] again to resume
transmission.
S O P
ELECTING AN UTPUT OWER
You can configure different power levels for transmission.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 6 (TXP).
2 Press [MENU] and turn the Tuning control to select "H"
(high; default) or "L" (low) power.
).
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
◆ Do not transmit at high output power for an extended period of
time. The transceiver could overheat and malfunction.
◆ Continuous transmission causes the heat sink to overheat.
Never touch the heat sink when it may be hot.
Note: When the transceiver overheats because of ambient high
temperature or continuous transmission, the protective circuit may
function to lower transmit output power.

SELECTING A FREQUENCY

VFO M
ODE
This is the basic mode for changing the operating
frequency. To enter VFO Mode, press [VFO].
Turn the Tuning control clockwise to increase the
frequency and counterclockwise to decrease the
frequency, or use Mic [UP]/[DWN].
• Press and hold Mic [UP]/[DWN] to step the frequency
repeatedly.
4
15