Initial Start-Up - MULTIQUIP FS2 Parts And Operation Manual

8. Grasp the starter grip (Figure 24) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
CAUTION: CAUTION: CAUTION:
CAUTION: CAUTION:
DO NOT pull the starter rope all the way
to the end.
DO NOT release the starter rope after
pulling. Allow it to rewind as soon as
possible.
Figure 24. Starter Grip
9. If the engine has started, slowly return the choke lever
(Figure 22) to the CLOSED position. If the engine has not
started repeat steps 1 through 5.
10. Before the saw is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard and/or covers.
11. All sawing is done at full throttle. Your engine governor has
been set at the factory to ensure an optimum speed setting.
MQ-WHITEMAN FS2/FS2SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (06/26/06) — PAGE 27
FS2/FS2SP CONCRETE SAW — INITIAL START-UP
Stopping the Engine
NEVER stop the engine while the blade is in the cut, except for
extreme emergencies. A sudden stoppage of the engine at high
speed while in a cut could damage the blade and/or saw, and
may cause injury to the user or other in the operating area.
1. Place the throttle lever (Figure 23) in the slow position, and
2. Push the console engine ON/OFF switch (Figure 21) to the
3. Place the engine ON/OFF switch (Figure 20) to the "OFF"
4. Place the fuel valve lever (Figure 19) to the "OFF" position.
Maneuvering The Saw
The blade is spinning whenever the engine is running.
Raise the blade high above the surface when maneuvering the
saw. Damage to the blade and/or saw may occur if the blade
strikes the pavement.
listen for the engine speed to decrease.
"OFF" position.
position.
WARNING
CAUTION: CAUTION: CAUTION:
CAUTION: CAUTION:
NEVER stop the engine in the cut while
working at high speeds, except for
extreme emergencies.