Using The Shockmount - Samson VR88 Owner's Manual

Using the Shockmount

Follow the steps below for mounting the VR88 to a mic
stand you can use the included "Spider" shockmount.
• First, screw the shockmount onto your mic stand or
boom arm. If you're using a US 5/8" mic stand or
boom, remove the Euro adapter.
• Install the VR88 into the shockmount by fitting the
microphone into the center of the holder, positioning
the VR88 all the way to the bottom mounting plate.
• Secure the shockmount by tightening the threaded
collar, rotating clockwise until tight.
• Now, loosen the thumb screw to adjust the angle
of the microphone and position the VR88 to the
desired location. Once set, tighten the thumbscrew
to secure the microphone in place.
Note: Be careful not to cross thread or over tighten
the threaded collar or thumb screw.
VR88 Active Velocity Ribbon Microphone
13