Error Indicators - Epson NPD4919-00 EN User Manual

User's Guide

Error Indicators

This section describes the solutions when an error code is displayed at the top-right of the LCD screen.
Code
E-01
E-02
E-10
W-01
W-02
W-03
W-10
W-12
W-13
I-22
I-23
I-31
I-60
I-71
I-73
Error Indicators
Solutions
Turn the printer off and then back on. Make sure that no paper is still in the printer. If the error still
appears, contact Epson support.
Turn the printer off and then back on. If the error message still appears, contact Epson support.
Turn off the printer. Contact Epson support to replace ink pads.
"Removing jammed paper from the paper cassette" on page 110
&
"Removing jammed paper from the rear cover" on page 108
&
"Removing jammed paper from inside the product" on page 109
&
"Removing jammed paper from the rear cover" on page 108
&
The ink cartridge(s) shown on the LCD panel have not been installed. Install them.
Cannot recognize the ink cartridge(s) shown on the LCD panel.
Replace the ink cartridge(s). Epson recommends the use of genuine Epson ink cartridges.
Press x to resume printing. The message will be displayed until the ink pad is replaced. Contact Epson
support to replace ink pads before the end of their service life. When the ink pads are saturated, the
printer stops and Epson support is required to continue printing.
To establish a wireless connection using an access point, press the push button on the access point or
click the button on the access point's wireless settings screen displayed on your computer's screen.
Refer the online Network Guide.
You need to enter the PIN code displayed on the printer's panel into the access point or computer
within two minutes. If no code is entered during the two minutes, a time-out error occurs and a
different code is displayed and needs to be entered.
To make wireless connection settings from your computer, you need to insert the CD into the
computer and follow the on-screen instructions.
If you are using Mac OS X, or if your computer does not have a CD/DVD drive, go to the following Epson
website and check how to configure wireless connection settings.
http://support.epson.net/setupnavi/
Your computer may not support WSD (Web Services for Devices).
The scan to PC (WSD) function is only available for computers running English versions of Windows 8,
7 or Vista.
1>2-Sided
& See "Placing Originals" on page 25
Book/2-Sided, A4, Book/2-up
& See "Placing a book" on page 26
A4, 2-up Copy
& See "Placing originals for 2-up copying (Layout copying)" on page 27
& See "Placing photos" on page 26
103