Connecting Power; Connecting Sl Bar 620 Rgbw Led Luminaires To Ac Power - Philips SL BAR 620 Installation & User Manual

Installation & User's Manual

2. Connecting Power

Units can be powered in one of two ways:
• Direct connection to a AC power source using an AC input cable. For wiring of AC input connector, refer to
necting SL BAR 620 RGBW LED Luminaires to AC Power"
• Connection from the AC output of another SL BAR 620 RGBW LED Luminaire. When using this method, it is
very important not to connect any other type of equipment device.
WARNING! Only connect other SL BAR 620 RGBW LED Luminaires to the AC Output (Thru) connector of a SL
BAR 620 RGBW LED Luminaire.

Connecting SL BAR 620 RGBW LED Luminaires to AC Power

If the unit is supplied with an AC input cable without an input connector installed. The input connector is a user-
supplied accessory.
Table 2 on page 8 describes how to connect power to your SL BAR 620 RGBW LED Luminaire. Field wiring of the
SL BAR 620 RGBW LED Luminaire is straight forward. The following wiring scheme is used:
Back of Unit
AC Input
AC Input Connector (on Unit)
Neutral
AC Connector
(on side of unit)
8
INSTALLATION AND SET UP
Table 2: SL BAR 620 RGBW LED Luminaire (IP20 Rated Models) AC Input Connections
Wire Color
Green/Yellow
Ground / Earth
Figure 4: SL BAR 620 RGBW LED Luminaire AC Input & Output Connections
below.
Brown Main / Line (100 to 240VAC)
Blue
Main /
Line
SL BAR 620 RGBW LED Luminaire
Purpose
Neutral
Ground (Earth)
AC Output Connector (on Unit)
Main /
Line
AC Connector
(on side of unit)
Ground / Earth
Sh wline
"Con-
AC Output
Neutral