E-Mu Xboard 25 Owner's Manual page 53

E-MU Xboard Control
Pedal/Footswitch Settings
MIDI Channel
CC Channel No
Initial
Pedal Setting
page 49.) The default setting for the Control Pedal is CC 64, which is the standard
MIDI sustain pedal number.
Octave / Semitone Transpose Settings
Note: Semitone Transpose is disabled when Zones are enabled.
Note Latch Mode Settings
Save Controller Values in Patch
Footpedal will be stored in the patch when the patch is stored via the Xboard front
panel. Note that this setting has no effect upon storage of patches from Xboard Control, in
which all settings are always stored to the Xboard exactly as they appear onscreen.
If this parameter is Off, the existing continuous controller settings are retained.
Xboard
The Control Pedal input accepts either a
momentary-on footswitch or a continuously
variable pedal. Like the other controllers, an initial
setting, CC number and MIDI channel can be
programmed. The MIDI Channel field allows you
to set the MIDI channel for the mod wheel. This
field is unavailable unless the "MIDI Channel
Number Per Control" option is selected (See
These settings allow you to transpose the keyboard
up or down in octave or semitone steps. The octave
transpose range is ±4 octaves. The semitone transpo-
sition range is -64 to +63 semitones.
This section allows you to program the high and
low keys for latch mode, as described on
You can also turn latch mode on or off by pressing
the amber-colored button. Note that you cannot
set a low key number higher than the high key, or
a high key number lower than the low key.
When this parameter is set to On, the
current initial value (position) settings
of the 16 Controller Knobs, the Pitch
Wheel, the Mod Wheel and the
page 29.
53