Accessories/Installation Procedure
Accessories
1
..........1
2
..........1
(2m)
Installation Procedure
1 To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness.
4 Connect the wiring harness wires in the
following order: ground, battery, ignition.
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
7 Reconnect the
-
8 Press the reset button.
9 Perform the Initial Setup.
WARNING
2
•
If you connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may
start a fire. Always connect those wires to the
power source running through the fuse box.
•
Do not cut out the fuse from the ignition wire
(red) and the battery wire (yellow). The power
supply must be connected to the wires via the
fuse.
3
..........8
4
1
*
..........1
1
*
DDX630WBT/
DDX630WBTM only.
-
battery.
After the Installation
After the installation, perform the Initial Setup
by referring to the instruction manual.
¤
•
Mounting and wiring this product requires
skills and experience. For best safety, leave the
mounting and wiring work to professionals.
•
Make sure to ground the unit to a negative 12V
DC power supply.
•
Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of
water splashing.
(3m)
•
Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
•
If the power is not turned ON ("Miswiring
DC Offset Error", "Warning DC Offset Error" is
displayed), the speaker wire may have a short-
circuit or touched the chassis of the vehicle and
the protection function may have been activated.
Therefore, the speaker wire should be checked.
•
If your car's ignition does not have an ACC
position, connect the ignition wires to a power
source that can be turned on and off with the
ignition key. If you connect the ignition wire to
a power source with a constant voltage supply,
such as with battery wires, the battery may be
drained.
•
If the console has a lid, make sure to install the
unit so that the faceplate will not hit the lid when
closing and opening.
•
If the fuse blows, first make sure the wires aren't
touching to cause a short circuit, then replace the
old fuse with one with the same rating.
•
Insulate unconnected wires with vinyl tape or
other similar material. To prevent a short circuit,
do not remove the caps on the ends of the
unconnected wires or the terminals.
•
Never cut away cable insulation to make the
proper connections may result in fire or product
damage.
•
Connect the speaker wires correctly to the
terminals to which they correspond. The unit may
be damaged or fail to work if you share the -
wires or ground them to any metal part in the car.
67
English