Lincoln MKT Owner's Manual page 159

2. Press and hold the control button
1 for five seconds. A tone will be
heard after about two seconds
confirming memory position has
been set. Continue to hold until a
second tone is heard after five
seconds.
3. Within three seconds press
the .
4. Wait 10 seconds, then press
the .
5. Repeat this procedure for memory 2 and another transmitter if
desired.
Deprogramming memory feature from transmitter
To deactivate this feature:
1. Press and hold either the 1 or 2 control on the driver's door for five
seconds. A tone will be heard after 1
is done, continue to hold until a second tone is heard after five seconds.
2. Within three seconds press the
3. Repeat this procedure for another transmitter if desired.
Replacing the battery
The intelligent access key (IA key) uses one coin type three-volt lithium
battery CR2032 or equivalent.
To replace the battery:
1. Remove the backup key from the
transmitter, then twist a thin coin in
the slot hidden behind the backup
key slot to remove the battery
cover.
Note: Do not wipe off any grease on
the battery terminals or on the back
surface of the circuit board.
2012 MKT (mkt)
Owners Guide, 1st Printing
USA (fus)
Locks and Security
1 ⁄ seconds when the memory store
2
.
159