Table of Contents
Advertisement
74
Displaying the Factory Set Code
Note: You will need to have two programmed intelligent access keys for
this procedure.
To display the factory-set code in the information display:
4. Insert the second programmed key into the backup slot, then press
the START/STOP button.
The factory-set code will appear in the information display for a few
seconds.
Note: The code may not display until after any other warning messages
first display.
TRUNK RELEASE
From Inside Your Vehicle
Press the button located on the instrument panel.
2014 MKS (mks)
Owners Guide gf, 1st Printing, April 2013
USA (fus)
Locks
1. Place the first programmed key in the
backup slot inside the center console. The
key ring must be at the top with the buttons
facing toward the rear.
2. Press the START/STOP button once and
wait a few seconds.
3. Press the START/STOP button again and
remove the key.
Advertisement
Table of Contents
