Lincoln MKS Owner's Manual page 145

Universal Garage Door Opener
Programming HomeLink to the Genie Intellicode garage door
opener motor
Note: You may need a ladder to access the garage door opener motor.
Note: The next two steps must be completed in 30 seconds.
4. Press and release the Genie Intellicode 2 hand-held transmitter's
previously programmed button. Both indicator lights on the garage door
opener motor unit should now flash purple.
5. Press and hold the previously programmed button on the sun visor for
2 seconds. Repeat this step up to 3 times until the garage door moves.
Programming is now complete.
At this point programming is complete.
Clearing a HomeLink device
To erase programming from the three HomeLink button s press and hold
the two outer HomeLink buttons until the indicator light begins to flash.
The led will begin flashing in 10 to 20 seconds, at which time both buttons
should be released. Programming has now been erased, and the led should
blink slowly to indicate the device is in train mode when any of the three
HomeLink buttons are pressed.
FCC and RSS-210 Industry Canada Compliance
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications to your device not expressly approved by the
party responsible for compliance can void the user's authority to operate the
equipment.
2013 MKS (mks)
Owners Guide gf, 2nd Printing
USA (fus)
To program HomeLink to the
garage door opener motor.
1. Press and hold the PROGRAM
button on the Garage door opener
motor until both blue LED's turn on.
2. Release the PROGRAM button.
Only the smaller round LED should
be on.
3. Press and release the program
button. The larger purple LED will
flash
145