Section 4 - Operation - Troy-Bilt 0020242-1 Owner's Manual

HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-888-611-6708.
Pressure Washer Location
Pressure Washer Clearance
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide will cause nausea,
fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure.
The pressure washer must be at least 5 ft. (152 cm) from
structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhead, for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 7). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
Figure 7 — Pressure Washer Clearance
Typical Pressure
Washer Shown
Exhaust Port
Operation
To Start Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.8 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Check that high pressure hose is connected to spray
gun and pump. See "Preparing Pressure Washer for
Use" for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON the water.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Squeeze trigger on gun until you have a steady stream
of water.This purges the pump of air and impurities.
6. Attach nozzle extension to spray gun (Figure 8).
Tighten by hand.
Figure 8 — Connect Nozzle Extension to Spray Gun
7. Choose desired ProjectPro™ nozzle, pull back nozzle
extension collar, insert nozzle and release collar.Tug on
nozzle to make sure it is securely in place (Figure 9).
See "How to Use ProjectPro™ Nozzle System".
Figure 9 - Attaching ProjectPro™ Nozzle to Nozzle Extension
8. Engage trigger lock to spray gun trigger (Figure 10).
Figure 10 — Spray Gun with Trigger Lock Engaged
9
Section
4
Trigger Lock