Table of Contents
Advertisement
•
M5 socket screwdriver
•
Allen wrench (included in the kit contents)
•
Measuring tape
A T screwdriver is optional to ease installation.
Installing the front automatic door release kit
Using a T-30 Torx screwdriver, remove the existing front door lock catches by removing the screw from
1.
each of the two front door lock catches.
Install the front electromagnetic lock
2.
Install the front strike plate
3.
Install the front door release spring
4.
Install the front magnetic lock cable
5.
Installation is complete.
CAUTION:
above and below the latch to open your rack front door.
Installing the front electromagnetic lock
On the front rack frame, count up from the bottom to locate the 40
1.
electromagnetic lock bracket with these holes (1).
("Installing the front electromagnetic
("Installing the front strike
("Installing the front door release
("Installing the front magnetic lock
HP recommends keeping your latch handle locked and using the fixed door handles
lock" on page 11).
plate" on page 13).
spring" on page 15).
cable" on page 17).
and 42
th
nd
Automatic Door Release Kit 11
holes. Align the
Advertisement
Table of Contents
