Automatic Operation - Saab 9-7x Owner's Manual

C
(Mode): Press this button to manually select the
air delivery mode to the floor, instrument panel, or
windshield outlets. The system will stay in the selected
mode until the mode button is pressed again or the
AUTO button is pressed.
Driver's Side Temperature Knob: Turn this knob
clockwise or counterclockwise to raise or lower
the temperature on the driver's side of the vehicle. The
display will show the temperature setting decreasing
or increasing and an arrow pointing toward the driver.
This knob can also adjust the passenger's side
temperature setting if the two are linked.
Passenger's Side Temperature Knob: Turn this
knob clockwise or counterclockwise to manually raise
or lower the temperature on the passenger's side of
the vehicle. The display will show the temperature
setting decreasing or increasing and an arrow pointing
toward the passenger. The passenger's temperature
setting can be set to match and link to the driver's
temperature setting by pressing and holding the
AUTO button for three seconds. When adjusting the
driver's side temperature setting, the passenger's
side temperature setting will follow and both arrows
will appear on the display. The passenger's side
temperature setting also resets and relinks to the
driver's side temperature setting if the vehicle has
been off for more than three hours.
Outside Air Temperature Display
A new outside temperature reading will be displayed
if the vehicle has been off for more than three hours.
If the vehicle has been off for less than three hours,
the old temperature reading may be displayed because
underhood heat is affecting the true outside temperature.
Underhood heat can also affect the outside temperature
while the engine is running. It may also take several
minutes of driving before the display updates to
the actual outside temperature.

Automatic Operation

AUTO (Automatic): When automatic operation is
active, the system will control the inside temperature,
the air delivery mode, and the fan speed.
Use the steps below to place the entire system in
automatic mode:
1. Press the AUTO button.
When AUTO is selected, the air conditioning
operation and air outlet mode will be automatically
controlled. The air conditioning compressor will
run continuously when the outside temperature
is over approximately 40°F (4°C). The air inlet will
normally be set to outside air. If it's hot outside,
the air inlet will automatically switch to recirculate
inside air to help quickly cool down your vehicle.
3-21