Remote Keypad User Codes; General; To Assign, Change, Or Delete User Codes - First Alert FA2000C User Manual

REMOTE KEYPAD USER CODES

General

To Assign, Change, or
Delete
User Codes
If your system has a remote keypad installed, your installer will have programmed
a 4-digit user code (known as User Number 2 code) that can be entered at your
keypad to silence/reset alarms, bypass protection zones and activate the fire drill
test. This code may also be used to assign up to four other user codes (known as
User Number 3Ð6 codes).
The User Number 3Ð6 codes are intended for users who need limited and/or
temporary control over system operation. These codes can perform the same
functions as the User Number 2 code except for assigning user codes and
activating the fire drill test.
User Number 2 can change, but not delete, his/her own code and can assign,
change, or delete codes for User Numbers 3Ð6.
User Numbers 3Ð6 cannot assign, change, or delete user codes.
1. Enter the User Number 2 code and press the CODE key.
2. Enter a single-digit User Number (2Ð6) for the user whose code is to be
assigned, changed, or deleted.
3. If assigning or changing a user's code, enter the new 4-digit code for that
user. The keypad will beep once, indicating that the new code has been
accepted.
If deleting a user's code, perform steps 1 and 2 and then stop. After a few
moments the keypad will beep once, indicating that the existing code has
been deleted.
Ð10Ð