Error Code Table - Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining

Troubleshooting
5.6.2

Error Code Table

Error Code Description
80 Barcode Reader Error, cannot
initialize BCR
81 Barcode Reader Error, no
response from BCR
82 EEPROM Error, no response
from EEPROM (located on robot
controller)
83 Robot controller generic problem Reset the unit and retry
84 Setting of gripper motor param-
eters failed
85 Setting of slider motor param-
eters failed
86 Setting of elevator motor param-
eters failed
87 Setting of rotation motor param-
eters failed
88 Setting of sled motor parameters
failed
ETERNUS LT20 S2
Tape Library Error Codes
User Action
Retry operation; after several
occurrences contact
technical support
Retry operation; after several
occurrences contact
technical support
Retry operation; after several
occurrences contact
technical support
operation. After several
occurrences contact
technical support
Reset the unit and retry
operation. After several
occurrences contact
technical support
Reset the unit and retry
operation. After several
occurrences contact
technical support
Reset the unit and retry
operation. After several
occurrences contact
technical support
Reset the unit and retry
operation. After several
occurrences contact
technical support
Reset the unit and retry
operation. After several
occurrences contact
technical support
93