HP ProLiant DL560 Specification page 3

Hp proliant dl560 generation8 (gen8)
Hide thumbs Also See for ProLiant DL560:
Table of Contents

Advertisement

QuickSpecs
Standard Features
On System Management
Processor
Memory Protection
Memory
One of the following
depending on Model
Network Controller
HP ProLiant Gen8 servers offer a new networking technology - Flexible Network Technology. The HP ProLiant
DL560 Gen8 server offers the customer the choice of 1 Gigabit and/or 10 Gigabit networking solutions. For
One of the following
additional details see the Networking Section of this document.
depending on Model
Entry Models
Base Models
High Performance Models
HP iLO (Firmware: HP iLO 4)
NOTE: For more information, visit:
Advanced ECC
NOTE: Advanced ECC uses single device data correction (SDDC) to detect and correct single and all multi-
bit error that occurs within a single DRAM chip. Both x4 and x8 SDDC are supported (x8 requires lockstep
mode).
Online Spare
NOTE: Memory online spare mode (also known as rank spare mode) detects a rank that is degrading and
switches operation to the spare rank.
Lock-step mode
NOTE: Memory Lockstep mode is used to correct a single x8 DRAM device failure on a DIMM. The DIMMs in
each paired memory channel must have identical HP part numbers.
Type
DIMM Slots Available
Standard (Entry Model)
Standard (Base Models)
Standard (High
Performance Models)
Maximum Capacity
(RDIMM)
NOTE: HP memory from previous generation servers are not qualified or warranted with this HP ProLiant
Server. HP SmartMemory is required to realize the memory performance improvements and enhanced
functionality listed in this document for Gen8. For additional information, please see the HP SmartMemory
QuickSpecs at:
http://h18000.www1.hp.com/products/quickspecs/14225_div/14225_div.html
NOTE: LRDIMM, RDIMM are all distinct memory technologies and cannot be mixed within a server. The
majority of ProLiant Gen8 servers support RDIMM, UDIMM and LRDIMM.
NOTE: If only one processor is installed, only a quarter the DIMM slots are available. If only two processors
are installed, only half the DIMM slots are available.
NOTE: Depending on the memory configuration and processor model, the memory speed may run at
1600MHz, 1333MHz, or 1066MHz. Please see Memory Population Table or the Online Memory
Configuration Tool at: www.hp.com/go/ddr3memory-configurator.
HP Ethernet 1Gb 4-port 331FLR Adapter
HP Ethernet 1Gb 4-port 331FLR Adapter
HP Ethernet 1Gb 4-port 331FLR Adapter
HP Ethernet 10Gb 2-port 530FLR-SFP+ Adapter
DA - 14395 Worldwide — Version 17 — December 13, 2013
HP ProLiant DL560 Generation8 (Gen8)
http://www.hp.com/go/ilo
HP SmartMemory
DDR3 Load Reduced (LRDIMM), Registered (RDIMM)
48 (12 DIMM slots per processor /4 channels per processor/3 DIMMs per
channel)
16GB (1x4GB) PC3L-10600R (DDR3-1333) Registered DIMMS
32GB (4x4GB) PC3L-10600R (DDR3-1333) Registered DIMMS
64GB (4x8GB) PC3-12800R (DDR3-1600) Registered DIMMS
1.5TB (48x 32GB RDIMM @1600MHz)
Page 3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Proliant dl560 generation8

Table of Contents