Table of Contents
Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on Factory
Integrated Model product offerings and requirements.
NOTE: HP does not allow factory integration of options into standard models listed above.
NOTE: Configure-to-order servers must start with a Factory Integrated Model (CTO) Blade.
NOTE: FIO indicates that this option is a Factory Installable Option.
Step 1: Base Server Blade Configuration (Select a configurable Blade)
HP Models
Step 2: Choose Required Options (one of the following from each list unless otherwise
noted):
HP Processors
HP ProLiant BL620c G7 W Configure-to-order Server
Configurable model ships with:
Four (4) integrated HP NC553i 10Gb FlexFabric adapter ports supporting 10Gb/1Gb
autosensing Ethernet, FCoE, Flex-10, TCP/IP offload engine, hardware-based
accelerated iSCSI, and iSCSI boot
One (1) 10/100 network adapter port dedicated to iLO 3 Management
One (1) Integrated SAS version 2.0 (6Gb) HP Smart Array P410i Controller with RAID 0
and 1
NOTE: The P410i is configured with no cache allowing the end user to select the desired
cache option (if cache is desired in the first place).
NOTE: RAID 0 and 1 are supported on the P410i without the need for a cache option.
Two (2) cache slots for BBWC and/or FBWC battery options.
NOTE: The server supports up to a combined total of two (2) battery cache options for
the P410i and/or optional Smart Array RAID controllers.
Two (2) small form factor hot-plug SAS/SATA/SSD hard drive bays
Three (3) I/O expansion slots
One (1) integrated Lights-Out 3
Integrated USB, MicroSDHC, and TPM connectors
NOTE: The BL620c G7 supports one or two processors.
NOTE: The minimum processor configuration is one processor that must be installed in
socket CPU1.
NOTE: All processors within the server must be identical.
NOTE: All Configure-to-Order processor kits contain one (1) processor.
NOTE: If two processors are desired, select one xxxxxx-L21 kit and one xxxxxx-B21 kit.
NOTE: Intel® Xeon® E7-2800/8867L series processors cannot be used to upgrade a
ProLiant BL620c G7 server blade with Intel® Xeon® 6500/7500 series processors.
Ten-Core Processors
HP BL620c G7 Intel® Xeon® E7-2870 (2.40GHz/10-core/30MB/130W) FIO Processor Kit
HP BL620c G7 Intel® Xeon® E7-2860 (2.26GHz/10-core/24MB/130W) FIO Processor Kit
HP BL620c G7 Intel® Xeon® E7-2850 (2.0GHz/10-core/24MB/130W) FIO Processor Kit
HP BL620c G7 Intel® Xeon® E7-8867L (2.13GHz/10-core/30MB/105W) FIO Processor Kit
Eight-Core Processors
DA - 13747 Worldwide — Version 35 — December 13, 2013
HP ProLiant BL620c Generation 7 (G7) Server Blade
643786-B21
643749-L21
643751-L21
643753-L21
643761-L21
Page 16
Advertisement
Table of Contents
