Honeywell FocusPRO TH5220D Installation Manual page 14

Installation Guide
Installer setup
Follow the procedure below to configure the thermostat to match the installed
heating/cooling system, and customize feature operation as desired.
To begin, press and hold the
buttons until the display changes
Setup Function
8 Emergency heat
cycle rate (CPH)
9 Compressor
cycle rate (CPH)
10 Second stage
compressor cycle
rate (CPH)
12 System setting
adjustment
14 Temperature
display
15 Compressor
protection
26 Auxiliary heat
control
27 Heat temperature
range stops
28 Cool temperature
range stops
and
F F A A N N
Settings & Options
9 For electric emergency heat
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
5 For gas or oil furnaces of less than 90% efficiency
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
0 Manual changeover (Heat/Cool/Off)
1 Auto changeover (Heat/Cool/Auto/Off)
2 Auto changeover only (Auto)
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time
[Other options: 0, 1, 2, 3 or 4-minute off time]
0 Comfort **See page 14
1 Economy
90 Highest heating temperature setting
40-89 Heating temperature range (increments of 1°F, or 0.5°C)
50 Lowest cooling temperature setting
51-99 Cooling temperature range (increments of 1°F, or 0.5°C)
Function
number
1
Done
Press
Press
N N E E X X T T
Press
D D O O N N E E
**See page 14
12
Setting
Next
or to change settings
to advance to next function
to exit and save settings
**See page 14
**See page 14
0