Using Network Function; Example Of Network Connection; Command Control - Panasonic TH-42PF20U Operating Instructions Manual

Using Network Function

This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each "NETWORK SETUP" setting and make sure to set the "CONTROL I/F SELECT"
to "LAN". (see page 54)
When "LAN" is set, the slot power is turned on, and power indicator is lit orange under the condition of power off with
remote control (stand-by state), regardless of the "Slot power" setting. (see page 57)

Example of Network Connection

COMPUTER
Ferrite core
(supplied)
Hub or broadband router
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use "category 5" LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.

Command Control

Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 13)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Less
than
3.9 inch
(10 cm)
LAN cable
(not supplied)
Ferrite core
(supplied)
Installing the Ferrite core
Less
than
3.9 inch (10 cm)
Pull back the tabs
(in two places)
Display (main unit, rear)
Open
Press the cable
Wind the cable
twice through and close
61