Ford F-150 Owner's Manual page 48

Deactivating and Activating the Belt-Minder® Feature
WARNING: While the design allows you to deactivate your
Belt-Minder, this system is designed to improve your chances of
being safely belted and surviving an accident. We recommend you leave
the Belt-Minder system activated for yourself and others who may use
the vehicle. To reduce the risk of injury, do not deactivate or activate
the Belt-Minder feature while driving the vehicle.
Note: The driver and front passenger Belt-Minder are deactivated and
activated independently. When deactivating or activating one seating
position, do not buckle the other position as this will terminate the
process.
Note: If you are using MyKey®, the Belt-Minder cannot be disabled.
Also, if the Belt-Minder has been previously disabled, it will be
re-enabled after the use of MyKey®. See the MyKey® chapter.
Read Steps 1 - 4 thoroughly before proceeding with the programming
procedure.
Before following the procedure, make sure that:
• the parking brake is set
• the transmission selector lever is in position P
• the ignition is off
• the driver and front passenger safety belts are unbuckled
1. Turn the ignition on. DO NOT START THE ENGINE.
2. Wait until the safety belt warning light turns off. (about one minute)
• Step 3 must be completed within 30 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, buckle then unbuckle the
safety belt three times, ending in the unbuckled state.
• After Step 3, the safety belt warning light will be turned on for
three seconds.
4. Within about seven seconds of the light turning off, buckle then
unbuckle the safety belt.
• This will disable the Belt-Minder feature for that seating position if it
is currently enabled.
• This will enable the Belt-Minder feature for that seating position if it is
currently disabled.
2013 F-150 (f12)
Owners Guide gf, 3rd Printing, February 2013
USA (fus)
Safety Belts 47