Cadillac 2014 ATS Owner's Manual page 257

Increasing Speed While ACC is at
a Set Speed
If ACC is already activated, do one
of the following:
Use the accelerator to get to the
higher speed. Press SET down.
Release the control and the
accelerator pedal. The vehicle
will now cruise at the higher
speed.
When the accelerator pedal is
pressed, ACC will not brake
because it is overridden.
A warning message will appear
on the Driver Information Center
(DIC) and the Head-Up Display
(HUD). See
Press and hold +RES up until
the desired set speed appears
on the display, then release it.
To increase vehicle speed in
small increments, press +RES
up to the first detent. For each
press, the vehicle goes 1 km/h
(1 mph) faster.
To increase vehicle speed in
larger increments, press +RES
up to the second detent. For
each press, the vehicle speed
increases to the next 5 km/h
(5 mph) mark on the
speedometer.
When it is determined that there is
no vehicle ahead inside the selected
following gap, then the vehicle
speed will increase to the set speed.
The speedometer reading can be
displayed in either English or metric
units. See
. The increment value
used depends on the units
displayed.
Reducing Speed While ACC is at a
.
Set Speed
If ACC is already activated, do one
of the following:
Use the brake to get to the
desired lower speed. Press
SET down and release the
accelerator pedal. The vehicle
will now cruise at the lower
speed.
Driving and Operating
Press and hold SET down until
the desired lower speed is
reached, then release it.
To decrease the vehicle speed in
small increments, press SET
down to the first detent. For
each press, the vehicle goes
about 1 km/h (1 mph) slower.
To decrease the vehicle speed in
larger increments, press SET
down to the second detent. For
each press, the vehicle speed
decreases to the next 5 km/h
(5 mph) mark on the
speedometer.
The speedometer reading can be
displayed in either English or metric
units. See
. The increment value
used depends on the units
displayed.
Selecting the Follow Distance
When a slower moving vehicle is
detected ahead within the selected
following gap, ACC will adjust the
9-43