InSinkErator F-201 Installation Instructions Manual page 2

INTRODUCTION
Read, understand, and follow all safety information contained in these instructions
prior to installation and use of the InSinkErator
System. Retain these instructions for future reference.
The InSinkErator Instant Hot Water Dispenser Filtration System is intended for use
in filtering sediment, chlorine taste and odor from drinking water, and has not been
evaluated for other uses. The system is typically installed (near or beneath a sink)
where filtered drinking water is desired, and must be installed, operated and
maintained as specified in the installation and use instructions.
A potentially hazardous situation, which, if not avoided, could result in death or serious injury.
Caution, used with the safety alert symbol, indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
Caution, without the safety alert symbol, is used to address practices not related to
personal injury.
COMPONENTS IN THIS PACKAGE
2
® Instant Hot Water Dispenser Filtration
A Filter Head and Bracket
B
F-201R Filter Cartridge
C Two Polyethylene Tubes
D "Y" Quick-Connector
Ferrule
E
F Tube Insert
G
Brass Nut
OVERVIEW OF A COMPLETED SETUP
To reduce the risk associated with property damage due to water leakage:
• Protect filter from freezing. Drain filter when temperatures drop below
40°F (4.4°C).
• Do not install if water pressure exceeds 120 psi (828 kPa). If your water
pressure exceeds 120 psi, you must install a pressure limiting valve.
Contact a plumbing professional if you are uncertain how to check your
water pressure.
• Do not install where water hammer conditions may occur. If water hammer
conditions exist you must install a water hammer arrester. Contact a
plumbing professional if you are uncertain how to check for this condition.
• Do not install on hot water supply lines. The maximum operating water
temperature of this filter system is 100°F (38°C).
• The disposable filter cartridge must be replaced every six months or at the
specified service cycle.
• Read and follow instructions before installation and use of this system.
To reduce the risk associated with ingestion of contaminates due to use with
water that is microbiologically unsafe or of unknown quality, do not use with
water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
3