Assembly - Weslo Cadence G25 Treadmill User Manual

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Do not remove the long wire is inside the Right
Handrail until told to. Note: The underside of the treadmill walking belt is coated with high-performance lubricant.
During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping car-
ton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the
lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench
adjustable wrenches
Note: To identify small parts used during assembly, see the PART IDENTIFICATION CHART in the center of
this manual. Some parts may be preassembled.
1. Attach the six
Base Pads
(19) to the
bottom of the
Base (71) with
six Base Pad
Screws (42).
Note: The Base Pads may be preassembled.
2. Have a second person hold the Base (71) in the position
shown.
Identify the Right Handrail (6), which has a large hole near
the lower end. Hold the Right Handrail so the bend is in
the position shown. Attach the Right Handrail to the
Base (71) with two Handrail Bolts (12) and two Nuts (17).
Do not tighten the Handrail Bolts yet.
Attach the Left Handrail (7) to the Base (71) in the same
way.
and your own phillips screwdriver
, and wire cutters
6
.
1
71
42
19
42
42
19
19
2
7
6
71
12
Large
Hole
17
12
,
42
19 42
19
Bend