Table of Contents
Advertisement
Reset Button
The switch can be reset by inserting a pin or paper clip into the reset
opening. See
Returning the Device to the Factory Default Settings,
page 19
for details.
Back Panel
The power connector and console port are located on the back panel of
the switch.
Console—The Console port is where you can connect a serial cable to a
computers serial port for configuration using a terminal emulation program.
DC Power and Ground—The Power and Ground connector is where you
will connect the switch to DC power and earth ground. The connections
from left to right are; earth ground, negative, and positive.
Review the warnings and information in the
DC Electrical Connections,
page 6
section before connecting power to the device.
18
Cisco ESW2 Series Advanced Switches
Advertisement
Table of Contents
