Physical Connection - Bosch DIVAR DIP-6080-00N Quick Installation Manual

DIVAR IP 6000 2U
4.3.2

Physical connection

To start the system:
The system comes with a VGA graphic connector and with PS2 connectors for mouse and
keyboard.
1.
2.
To configure the IP address:
1.
2.
Bosch Sicherheitssysteme GmbH
Connect a monitor, mouse and keyboard (not part of the shipment) to the disk array and
start up the system.
Note:
When connecting a PS2 mouse or keyboard device after the system has been booted it
will most likely not operate properly.
When the system has started up, press Ctrl+Alt+Del, then type the default password
WSS4Bosch once the disk array login window is displayed.
After starting the system, on first login the desktop default settings are applied. This will
take a few seconds and the system will reboot. After system reboot, log on again and the
Bosch VRM Appliance initial configuration window will be shown. Use this program to
configure the disk array's IP Address.
The top level view of Bosch VRM Appliance initial configuration displays an overview of
the system's configuration and settings. Select the link Configure networking to get
access to the network configuration.
For each network port a separate icon is shown. Select the Local Area Connection icon
that shows the status network, then double-click the icon.
Quick Installation Guide
System Setup – first Steps | en
2013.05 | V3 | DOC
19