Pioneer DV-545 Operating Instructions Manual page 34

Adjusting the picture quality settings
To create your own setting (1)
1
Move the Joystick right to select [Start]
then press ENTER.
You can also access these settings by pressing
VIDEO ADJUST (V. ADJ) on the remote control
unit.
Video Memory Select
Video Setup
2
Move the Joystick down to select [Video
Setup] then press ENTER.
Video Memory Select
Video Setup
3
Move the Joystick left or right to select the
setting to [On] or [Off].
Fine Focus
Move
4
Move the Joystick up or down to select
the setting to adjust.
You can adjust any or all of the following picture
quality factors:
Fine Focus
Switch on to reveal greater detail (higher resolution)
in the picture.
Contrast
Adjusts the contrast of the elements in the picture.
Sharpness
Adjusts the sharpness of the mid-frequency (less
detailed) elements in the picture. (This setting is
only effective when [Fine Focus] is [On].)
Chroma Level
Adjusts how saturated colours appear.
Hue
Adjusts the overall colour balance between red and
green. (This is only effective when the player is
connected using the VIDEO OUT or S-VIDEO
OUT jacks.)
5
Move the Joystick left or right to adjust
the settings.
Adjust these while a disc is playing to see the effect
32
of changes immediately.
En
On Off
Select DISPLAY Check
ENTER
6
Repeat steps 4 and 5 to make adjustments
to other settings.
If you would like to save the settings in the player's
memory, be sure to select either [1], [2], or [3] in
the [Memory] setting to establish which memory
location to save the new settings in. Please note
that if you select a location where settings have
already been saved, the old settings will be
replaced by the new ones.
Memory
Move
7
When you are finished making
adjustments, press ENTER to establish the
new settings.
To create your own setting (2)
1
Move the Joystick right to select [Start]
then press ENTER.
You can also access these settings by pressing
VIDEO ADJUST (V. ADJ) on the remote control
unit.
Video Memory Select
Video Setup
2
Move the Joystick down to select [Video
Setup] then press ENTER.
3
Press DISPLAY.
Fine Focus
Contrast
Sharpness
Chroma Level
Hue
Memory
4
Move the Joystick up or down to select
the setting and move the Joystick left or
right to adjust the settings.
Adjust these while a disc is playing to see the effect
of changes immediately.
5
To memorize the setting, select [Memory1,
2, 3], then press ENTER.
The previous setting will be erased.
Off 1 2 3
Select DISPLAY Check
ENTER
On Off
min max
soft fine
min max
green red
Off 1 2 3