Casio 2318 General Manual

Module No. 2318/2319
Press B B B B B to change from mode to mode.
Calendar Mode
ABOUT THE BACKLIGHT (Module 2319 only)
Hold down L L L L L to illuminate the display for about 2 seconds. The backlight is dis-
abled while an input screen (with a flashing setting) is on the display.
The backlight of this watch employs an electro-luminescent (EL) light, which loses
its illuminating power after very long term use.
Frequent use of the backlight shortens the battery life.
The watch emits an audible sound whenever the display is illuminated. This does
not indicate malfunction of the watch.
The illumination provided by the backlight may be hard to see when viewed under
direct sunlight.
The backlight automatically turns off whenever an alarm sounds.
This is the normal mode for this watch.
To set the date
Hour hand Minute hand
Second hand
Day Day of week
1. Hold down A A A A A until the ADJ indicator starts to flash, followed by flashing of the year
digits.
2. Press B B B B B to increase the year digits. Holding down B B B B B changes the digits at high
speed.
3. Press A A A A A to move the selection to month digits.
4. Press B B B B B to increase the month digits. Holding down B B B B B changes the digits at high
speed.
5. Press A A A A A to move the selection to the day digits.
6. Press B B B B B to increase the day digits. Holding down B B B B B changes the digits at high
speed.
7. Press A A A A A to complete the procedure.
If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Calendar Mode automatically.
The date can be set with the range of January 1,1995 to December 31, 2039.
The day of the week changes automatically in accordance with the date.
TIMEKEEPING MODE
Use this mode to set the current time. An incorrect time setting will result in incor-
rect operation of the calendar.
Crown
Hour Minutes
Press A A A A A .
Press A A A A A to switch the display between Hour/Minutes
and Seconds.
Seconds
To set the time
1. Hold down A A A A A until the ADJ indicator starts to flash, followed by flashing of the
seconds digits.
2. Press B B B B B to reset the seconds to 00. If you press B B B B B while the seconds count is in
the range of 30 to 59, the seconds are reset to 00 and 1 is added to the minutes. If
the seconds count is in the range of 00 to 29, the minutes count is unchanged.
3. Press A A A A A to move the selection to the hour digits.
4. Press B B B B B to increase the hour digits. Holding down B B B B B changes the hour digits at
high speed.
5. Press A A A A A to move the selection to the minutes digits.
6. Press B B B B B to increase the minutes digits. Holding down B B B B B changes the minutes
digits at high speed.
7. Press A A A A A to move the selection to 12/24.
8. Press B B B B B to toggle the timekeeping format between 12-hour and 24-hour.
9. Press A A A A A to complete the procedure.
If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Timekeeping Mode automatically.
Timekeeping Mode
Crown
CALENDAR MODE
Crown
Year Month
Seconds Hour
12/24 Minutes
GENERAL GUIDE
Crown
To set the hands
1. When the second hand is at 12 o'clock position, stop it by pulling the crown out.
2. Set the hands by turning the crown.
3. Press the crown in on a time signal.
When the Daily Alarm is turned on, an alarm sounds for 20 seconds at the preset
time each day.
To set the Alarm Time
1. Hold down A A A A A until the ADJ indicator starts to flash, followed by flashing of the hour
digits of the alarm.
The alarm turns on at this time.
2. Press B B B B B to increase the hour digits. Holding down B B B B B changes the digits at high
Day
speed.
3. Press A A A A A to move the selection to the minutes digits.
4. Press B B B B B to increase the minutes digits. Holding down B B B B B changes the digits at high
speed.
5. Press A A A A A to complete the procedure.
If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Alarm Mode automatically.
To stop the alarm
Press any button to stop the alarm after it starts to sound.
To turn the Daily Alarm on and off
Press A A A A A while in the Alarm Mode to turn the Daily Alarm on and off.
To test the alarm
Hold down B B B B B to sound the alarm.
To set the Dual Time
1. Hold down A A A A A until the ADJ indicator starts to flash, followed by flashing of the hour
digits.
2. Press B B B B B to increase the hour digits. Holding down B B B B B changes the digits at high
speed.
3. Press A A A A A to move the selection to the minutes digits.
4. Press B B B B B to increase the minutes digits. Holding down B B B B B changes the digits at high
speed.
5. Press A A A A A to complete the procedure.
In the Dual Time Mode, the seconds count is not displayed. But it is synchronized
with the seconds count of the Timekeeping Mode.
If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Dual Time Mode automatically.
The format(12-hour and 24-hour) of the Dual Time Mode matches the format you
select for normal timekeeping.
Alarm Mode Dual Time Mode
ALARM MODE
A LN
Hour
Hour Minutes
Press A A A A A .
DUAL TIME MODE
0
Hour
Hour Minutes
Minutes
Minutes