Audio Out Settings - Pioneer DVR-5100H Operating Instructions Manual

The Initial Setup menu
13
Bilingual Recording
• Default setting: A/L
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
When recording a bilingual source from an external input
in Video mode or VR mode set to FINE/MN32, or to the
HDD, you can choose to record either the A/L (left), or
the B/R (right) audio channel.
Note
• If you're recording in VR mode (except when set to
FINE/MN32), both channels will be recorded and you
can switch them as you like on playback.
DV Input
• Default setting: Stereo1
You need to set this if you have a camcorder using 32kHz/
12-bit sound connected to the front panel DV IN/OUT jack.
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
Some digital camcorders have two stereo tracks for
audio. One is recorded at the time of shooting; the other
is for overdubbing after shooting.
On the Stereo1 setting, the sound that was recorded
while shooting is used. On the Stereo2 setting, the
overdubbed sound is used. You can also choose a Mix
setting of 25%, 50% or 75% for the Stereo 1 with a
corresponding Stereo 2 setting of 75%, 50% or 25%.
Input Level (L1 / L2 / L3)
• Default setting: 0dB
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
102
En
NICAM Select A/L
Tuner Level B/R
External Audio
Bilingual Recording
DV Input
Input Level (L1)
Input Level (L2)
Input Level (L3)
NICAM Select Stereo1
Tuner Level Stereo2
External Audio Mix (Stereo1: 75%)
Bilingual Recording Mix (Stereo1: 50%)
DV Input Mix (Stereo1: 25%)
Input Level (L1)
Input Level (L2)
Input Level (L3)
NICAM Select +6dB
Tuner Level +3dB
External Audio 0dB
Bilingual Recording – 3dB
DV Input – 6dB
Input Level (L1)
Input Level (L2)
Input Level (L3)
You can adjust the gain of the audio from each external
input individually, from –6dB to +6dB in steps of 3 dB to
optimize the recorded audio level.

Audio Out settings

Digital Out
• Default setting: On
Initial Setup
Basic Digital Out
Tuner Dolby Digital Out
Video In/Out DTS Out
Audio In 96kHz PCM Out
Audio Out MPEG Out
Language
Recording
Playback
If at any time you need to switch off the digital audio
output, set this to Off, otherwise leave it On.
Note
• When set to Off, all the other Audio Out settings are
grayed out and can't be set.
Dolby Digital Out
You only need to make this setting if you connected this
recorder to an AV amplifier (or other component) using the
digital output.
• Default setting: Dolby Digital
Initial Setup
Basic Digital Out
Tuner Dolby Digital Out
Video In/Out DTS Out
Audio In 96kHz PCM Out
Audio Out MPEG Out
Language
Recording
Playback
If your AV receiver (or other connected component) is
Dolby Digital compatible, set to Dolby Digital, otherwise
set to Dolby Digital PCM. Check the manual that
came with the connected component if you're unsure
whether it is Dolby Digital compatible.
On
Off
Dolby Digital
Dolby Digital PCM